NISSAN CVT TRANSMISSION FILTER HOW TO

Check the transmission fluid level and add more fluid if necessary. Start the engine and let it idle for a few minutes. Replace the fill plug and tighten it to the specified torque. Fill the transmission with the specified amount and type of CVT fluid. Remove the transmission fill plug, which is located on the side of the transmission.

Once the fluid has finished draining, replace the drain plug and tighten it to the specified torque. Use a wrench to loosen the drain plug and allow the fluid to drain out. Place a drain pan under the transmission fluid drain plug, which is located on the bottom of the transmission pan. Park the Rogue on a level surface and set the parking brake.

NISSAN CVT TRANSMISSION FILTER HOW TO

Here’s a step-by-step guide on how to change the CVT transmission fluid in a Nissan Rogue: 1. The Rogue uses a special type of CVT fluid, so be sure to use the correct fluid when topping off or changing the fluid. To prevent these problems, Nissan recommends changing the transmission fluid every 37,500 miles (60,000 km). This can be caused by the transmission fluid breaking down or by debris clogging the fluid filter. However, the CVT can be prone to problems, and one of the most common is overheating.

This allows the engine to always operate at its most efficient speed, which improves fuel economy. The CVT is a type of automatic transmission that uses a pulley and belt system to provide an infinite number of gear ratios. It’s built on the same platform as the Nissan Sentra and shares many of its components, including the CVT.

The Rogue is a compact crossover SUV that’s been in production since 2007. If you own a Nissan Rogue equipped with a continuously variable transmission (CVT), it’s important to change the transmission fluid regularly.

Nissan cvt transmission filter